Danby DCR017A2WDB Operations Instructions download pdf (Page 6)

Operating Instructions

TEMPERATURE

SELECTION

To avoid vibration, the unit must be on a level surface. This is

accomplished by adjusting the leveling legs located under the refrigerator.

The temperature of the refrigerator is controlled by setting the thermostat

knob to a desired setting.

BEFORE USING

1. Before the refrigerator is plugged in make sure the electric voltage to

be used is the same as the rated voltage. The power plug should have

its own independent socket. Using an adapter may cause the socket to

overheat.

2. Do not store flammable materials such as ether, benzine, LP gas and

glue etc in the refrigerator.

3. Do not splash water on the refrigerator, it may cause a malfunction or

electric shock.

4. When operating the refrigerator for the first time, run it without loading

any food until it auto stops at the desired temperature, usually it takes

2 or 3 hours. Then set the thermostatic dial at the setting desired and

put food in the refrigerator.

Features

1) THERMOSTAT DIAL: For controlling the temperature

inside the refrigerator; the compressor activates as

soon as the temperature rises above the desired level.

2) FREEZER COMPARTMENT WITH FREEZER DOOR:

Separate freezer section can hold small items.

3) WIRE SHELF

4) DRIP TRAY: Catches the water that drips off the

evaporator when defrosting. (not shown)

5) MAGNETIC GASKET: Tight fitting door seal keeps all

the cooling power locked inside. No hooks or latches.

6) BOTTLE RACKS: For tall, small and medium cans or

jars.

7) Leveling legs: Adjust so the unit is leveled on the

surface.

1.The temperature of the refrigerator can be adjusted by turning the

thermostatic dial. A medium setting of the thermostatic dial is the most

suitable for general operation. (Fig.B)

2.Defrost the freezer compartment whenever the layer of frost on the

surface of the evaporator reaches 3 or 4 mm. When defrosting, remove

all food and set the thermostat to the “OFF” position. Put the drip tray

under the evaporator to collect melted water. After the frost has melted,

discard the melted water and dry up the interior of refrigerator. The

refrigerator can then be restarted by turning its thermostat to the desired

setting.

Fig.A - MAX

Fig.B - MED

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments

Danby DCR017A2WDB Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Unknown Danby DCR017A2WDB