Danby DBC259BLP User Manual download pdf (Page 5)

FEATURES

FEATURES OF YOUR

BEVERAGE CENTER

1) Tempered Glass Door: Tinted for UVprotection while still

allowing for easy interior viewing.

2) Magnetic Door Gasket: Tight fitting seals retain all the

cooling power.

3) Plastic Coated Wire Bottle Shelf

4) Plastic Coated Wire Can Shelves

5) Leveling Legs

THE CONTROLS OF

YOUR BEVERAGE

CENTER

To start the Beverage Center, turn the temperature control to the position

corresponding to the desired cooling. The Beverage Center temperature will vary

depending on the quantity of cans stored and on the frequency with which the

door is opened.

Setting The Temperature Control:

The temperature of the Beverage Center compartment

is controlled by adjusting/setting the thermostat

control knob, located on the exterior rear wall of the

cabinet. To start the Beverage Center and achieve

maximum cooling quickly;

• Turn the temperature control knob clockwise to the

furthest ‘Max’ (maximum) setting on the wider blue

section of the graduated control dial.

• Allow the unit to run at this setting for 3-4 hours.

• When maximum cooling is achieved, turn back the

temperature control knob setting to the 10 o’clock

position on the graduated blue control dial. See Fig.

• To turn off the beverage center, (no cooling) rotate

the control knob to the “O”(off) position. See Fig. B.

Fig. A

Fig. B

Turn the control to the “O” (off) position to temporarily disconnect the cooling cycle. When the beverage

center is not to be used for a long period of time, disconnect the plug and leave the door partially open.

NOTE: Wait 3 to 5 minutes before restarting if operation has been interrupted.

Defrosting: Your beverage center is designed with an “Auto-Cycle” defrost system. What is Auto Cycle

defrost? The refrigerated surfaces of the fresh food compartment defrost automatically during the “off”cycle

of the cold control (thermostat). Defrost water from the fresh food compartment is disposed of automatically,

by means of being channeled onto a drip tray located on the compressor. Heat transfer from the compressor

causes the defrost water to evaporate.

OPERATING INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 ... 16 17

Comments to this Manuals

No comments

Danby DBC259BLP User Manual Page 5

Comments to this Manuals

Related products and manuals for Unknown Danby DBC259BLP