Danby DCD5505W-1 USA ONLY Owner's Manual download pdf (Page 12)

OPERATING INSTRUCTIONS

Instructions for Use

11

The drying temperature is selected automatically

by the selection of the drying program, and it is

lower for delicate laundry than for the resistant

one. During the drying program with preset time

the temperature is the same for both the delicate

and resistant laundry.

Drying stage indicator

Damp for machine ironing

Damp for ironing

Mildly damp

Dry for storage

Very dry

Anti crease

End

The drying stage indicator displays the actual

drying stage at any given moment. This is

signaled by the indicator light, illuminated

adjacent to a particular drying stage symbol. The

end of drying is signaled by the indicator light

END or ANTI-CREASE.

START button

This button starts the operation of the appliance.

In case of program interruption (open door,

voltage failure, condensation receptacle full), it

serves to continue the actual program, after the

cause for interruption had been removed.

Drying

Drying time depends upon the selected program

and the quantity of laundry. If you selected time

defined drying the machine stops upon the expiry

of set time. If you selected any of the programs

for automatic determination of moisture, drying

time will largely depend upon the quantity of

laundry and the extent of moisture present in the

laundry (after the final spin stage of the wash

program).

Actual stage of moisture during the program is

indicated by the moisture stage display, so you

may remove particular pieces of clothing you

wish to remain damp at any time during the

program. When you open the door (add or

remove pieces of laundry) the drying program

stops automatically and the drum interior is

illuminated. When you close the door the light

goes off and the program continues by pressing

the START button.

In case of a power failure during a selected

program, the drying operation stops. When the

power is reinstated, you must to press the

START button to continue the program.

Each program concludes with a 10 minute

cooling down period, to prevent extracting hot

laundry from the appliance and to improve the

anti-crease function.

Drying programs are complete when the signal

beep sounds and the indicator light “END” and

“ANTI-CREASE” illuminate at the end of the

program. This indicates that the laundry is dried

to the point of the preset moisture stage, or the

preset drying time has expired. The drum stops

and laundry may be removed from the machine.

NOTE: If the laundry is not removed immediately

after the drying cycle is completed, (and the

machine is not switched off) the dryer will

automatically start a special anti crease program.

ANTI-CREASE PROGRAM: Consist of:

• 5 minute “OFF” (dormant) cycle

• 5 second “ON” tumbling cycle (ho heat)

This program helps to prevent laundry from

sitting idle in the same position and helps to

reduce creasing/wrinkling. The “anti-crease”

program stops automatically after one hour of

operation, but may be interrupted at any time by

opening the door or turning the appliance off.

After drying

• Open the dryer door. Remove and clean the lint

filter. If the filter is not cleaned regularly, the air

circulation is obstructed. This obstruction will

increase the drying time and may cause the

unit to overheat and fail.

• Reinsert the filter.

• Remove laundry from the drum.

• Close the door and disconnect the power

supply.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments