Danby DMW07A2SSDD User Manual download pdf (Page 10)

1. Make sure that all the packing materials are removed from the inside of the door or on cabinet surface. Do not remove

the light brown mica sheet that is attached to the oven cavity to protect the magnetron.

2. Check the oven for any damage, such as a misaligned or bent door, damaged door seals and sealing surface, broken

or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the

oven but contact qualiﬁ ed service personnel

3. This microwave oven must be placed on a ﬂ at, stable surface to hold its weight and the heaviest food likely to be

cooked in the oven.

4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustible materials.

5. For correct operation, the oven must have sufﬁ cient airﬂ ow. Allow 30cm of space above the oven, 7.5cm at back and

7.5cm at both sides (see diagram.) Do not cover or block any openings on the appliance. Do not remove feet on which

oven stands.

6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.

7. Make sure that the power supply cord is undamaged and does not run under the oven or over any hot or sharp surface.

8. The socket must be readily accessible so that it can be easily unplugged in an emergency. The socket must have the

same voltage and frequency as the rating label of the appliance.

9. Place the microwave oven away from radios and tvs to avoid interference.

3.0 inch(7.5cm)

12 inch(30cm)

OPEN

PART NAMES

1) Door Safety Lock System

2) Oven Window

3) Roller ring

4) Control panel

5) Light brown mica sheet

6) Glass tray

INSTALLATION GUIDE

OPERATING INSTRUCTIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 50 51

No comments

Danby DMW07A2SSDD User Manual Page 10