Danby DPA100D1MDD User Manual download pdf (Page 13)

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this

troubleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot

or Danby’s Toll Free Number 1-800-263-2629 for assistance.

PROBLEM POSSIBLE CAUSE SOLUTION

The A/C doesn’t work Not plugged in.

The display panel displays “FL”.

Timer TURN OFF function is

started.

Plug the unit in.

The A/C starts frequently Direct sunlight

Doors and windows are open;

there are many people or heat

sources in the room.

Filter is very dirty.

Air inlet or air outlet is blocked.

Close the curtain or blinds.

Close doors and windows, remove

heat source.

Clean or replace it.

Remove the blockage.

Loud noise from the A/C The A/C is placed on an uneven

surface.

Place it on even and strong

ground, avoid shaking.

The compressor doesn’t work Its delay protection is activated. Wait for 3min., turn on after tem-

perature decreases.

Power off A/C and drain water.

Restore power.

The A/C can be restarted 3

minutes after being turned off.

TROUBLESHOOTING

CARE AND MAINTENANCE

Error-detecting code Cause

E1 Error with the coils temperature sensor.

E2 Error with the indoor temperature sensor.

E4 Frost protection: the temperature of the coil is too low and the A/C shuts down to

prevent excess frost build-up. When the temperature increases to 8°C (46.4°F), the

protective setting is released and the previous setting is applied.

INTELLIGENT ERROR

DETECTION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

No comments

Danby DPA100D1MDD User Manual Page 13