Danby DFF501WDD User Manual download pdf (Page 9)

Adjusting the Control

Give the refrigerator time to cool down completely before adding

food. It is best to wait 24 hours before putting food into the

refrigerator. The control is set correctly when milk or juice is as

cold as you like. Move the dial one setting at a time and wait

24 hours between adjustments.

IMPORTANT: If you add food before the refrigerator has cooled

completely, your food may spoil. Turning the Temperature Control

to a colder (higher) than recommended setting will not cool the

compartment any faster.

NOTE: During high humidity, moisture may form on the outside of

the refrigerator. To avoid rust, dry the refrigerator’s exterior and

reset the Temperature Control to a colder (higher) setting.

REFRIGERATOR FEATURES

Refrigerator Shelves

Store similar foods together and adjust the shelves to fit different

heights. This reduces the time the refrigerator door is open and

saves energy.

To remove and replace a shelf:

1. Remove the shelf by pulling it forward slightly to align the shelf

stops with the openings in the refrigerator compartment liner.

Lift straight up, and pull the shelf out the rest of the way.

2. Replace the shelf by lowering the shelf stops through the

openings in the refrigerator compartment liner. Slide the shelf

in the rest of the way.

Crispers and Meat Drawer

Drawers

To remove and replace a drawer:

1. Slide drawer straight out to the stop. Lift the front of the

drawer and slide it out the rest of the way.

2. Replace a drawer by sliding it back in fully past the stop.

Crisper Cover

To remove the crisper(s) cover:

1. Remove crisper(s). Hold the glass insert firmly with one hand

and press up in the center of the glass insert until it rises

above the plastic frame. Slowly slide the glass insert forward

to remove.

2. Lift the cover frame and remove it.

To replace crisper cover:

1. Fit the back of the cover frame into the supports on the side

walls of the refrigerator. Lower the front of the cover frame into

place.

2. Slide the rear of the glass insert into the cover frame and lower

the front into place.

Adjustable Meat Drawer (on some models)

The meat drawer can be placed on either the right or left side of

the refrigerator.

To move the meat drawer:

1. Remove the meat drawer and cover. See “Refrigerator

Shelves” section.

NOTE: The meat drawer cover has one fixed support that runs

down the center of the shelf. The outside support is the adjustable

one.

2. Using a Phillips screwdriver, remove the adjustable support

and move it to the other side of the meat drawer cover.

3. Place the meat drawer cover in the desired location and slide

the meat drawer back into position.

Meat Storage Guide

Store most meat in original wrapping as long as it is airtight and

moisture-proof. Rewrap if necessary. See the following chart for

storage times. When storing meat longer than the times given,

freeze the meat.

Fresh fish or shellfish.........................use same day as purchased

Chicken, ground beef, variety meats (liver)......................1-2 days

Cold cuts, steaks/roasts ..................................................3-5 days

Cured meats...................................................................7-10 days

Leftovers - Cover leftovers with plastic wrap, aluminum foil, or

place in containers with tight fitting lids.

Important information to know about glass shelves

and covers:

Do not clean glass shelves or covers with warm water when

they are cold. Shelves and covers may break if exposed to

sudden temperature changes or impact, such as bumping.

Tempered glass is designed to shatter into many small,

pebble-size pieces. This is normal. Glass shelves and covers

are heavy. Use both hands when removing them to avoid

dropping.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Comments to this Manuals

No comments

Danby DFF501WDD User Manual Page 9

Comments to this Manuals

Related products and manuals for Fridges Danby DFF501WDD