Danby DFF501WDD User Manual download pdf (Page 5)

Electrical Requirements

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator be provided. Use an outlet

that cannot be turned off by a switch. Do not use an

extension cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the Temperature Control to the OFF

position as shown and then disconnect the refrigerator from the

electrical source.

When you are finished, reconnect the refrigerator to the electrical

source and reset the Temperature Control to the desired setting.

See “Using the Control.”

Refrigerator Door

TOOLS NEEDED: ⁵⁄₁₆" hex head socket wrench, ⁵⁄₈" hex head

socket wrench, ¹⁄₄"hex head socket wrench, ¹⁄₂" hex head socket

wrench, ³⁄₈" hex head socket wrench, #2 Phillips screwdriver, flat-

blade screwdriver, ⁵⁄₁₆" open-end wrench, flat 2" putty knife.

IMPORTANT:

■ All graphics referenced in the following instructions are

included later in this section after “Final Steps.” The graphics

shown are for a right-hand swing door (hinges factory installed

on the right).

■ If you only want to remove and replace the door, see the

“Remove Door and Hinges” and “Replace Door and Hinges.”

■ Before you begin, turn the control OFF, and remove food and

adjustable door or utility bins from door.

Remove Door and Hinges

⁵⁄₁₆" Hex Head Hinge Screw

1. Unplug refrigerator or disconnect power.

2. Open refrigerator door and remove base grille from the bottom

front of the refrigerator. See Base Grille Graphic 1A.

3. Close the refrigerator door and keep it closed until you are

ready to lift it free from the cabinet.

NOTE: Provide additional support for the door while the

hinges are being moved. Do not depend on the door magnets

to hold the door in place while you are working.

4. Remove the parts for the top hinge as shown in Top Hinge

Graphic 1B.

5. Lift the refrigerator door free from the lower hinge and cabinet

and set aside.

6. Remove 3 hex head hinge screws and bottom hinge

assembly. See Bottom Hinge Graphic 1C.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 3 4 5 6 7 8 9 10 ... 26 27

Comments to this Manuals

No comments

Danby DFF501WDD User Manual Page 5

Comments to this Manuals

Related products and manuals for Fridges Danby DFF501WDD