Danby SBWC033A1S User Manual download pdf (Page 7)

Fig. 2

Fig.1

OPERATING INSTRUCTIONS

SETTING THE TEMPERATURE:

The temperature of the wine cooler compartment is con-

trolled by adjusting/setting the thermostat control knob,

located on the exterior rear wall of the unit. To start the

wine cooler and achieve maximum cooling quickly:

• Turn the temperature control knob clockwise to the

furthest (maximum) setting on the darkest blue/widest

section of the graduated control dial. See Fig. 1.

• Allow the unit to run at this setting for 3-4 hours.

• When maximum cooling is achieved, turn back the

temperature control knob setting to the 2 o’clock posi-

tion on the graduated blue control dial.

• To turn off the wine cooler (no cooling), rotate the con-

trol knob to the “0” (off) position. See Fig. 2. This tem-

porarily turns off the cooling cycle. When the wine cool-

er is not to be used for long periods of time, disconnect

from power and leave the door partially open.

NOTE: Wait 3 to 5 minutes before restarting if operation

has been interrupted.

Interior Light:

To manually operate the light, depress the interior light

toggle switch situated on the left side of the interior light

housing, located on the ceiling inside the unit: This will

allow the interior light to remain on while the door is

closed.

DEFROSTING: Your wine cooler is designed with an

“Auto-Cycle” defrost system. What is Auto-Cycle

defrost?

The refrigerated surfaces of the fresh food compartment

defrost automatically during the “off” cycle of the ther-

mostat. Defrost water from the fresh food compartment

is disposed of automatically, by means of being chan-

neled onto a drip tray located on the compressor. Heat

transfer from the compressor causes the defrost water

to evaporate.

CONTROLS OF YOUR WINE

COOLER

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

No comments

Danby SBWC033A1S User Manual Page 7