Danby DDW621WDB Owner's Manual download pdf (Page 18)

Installation Instructions

WATER

CONNECTION

(cont)

1. Screw the faucet adapter onto (or into) the faucet tap. Check for leaks

(use Teflon tape to eliminate if necessary).

2. Connect the six-sided connection of the drain hose to the drain port

connection on the back of the dishwasher cabinet. Do not over-tighten (to

avoid damage to threads).

3. Connect the star-shaped connection of the inlet hose to the inlet port

on the back of the dishwasher cabinet. Do not over-tighten (to avoid dam-

age to threads).

4. Connect the circular connection of the drain hose onto the longer (bot-

tom) male connection on the quick connect.

5. Connect the circular connection of the inlet hose onto the shorter (top)

male connection on the quick connect.

6. Attach the quick connect onto the faucet adapter, by pulling down the

outer locking collar on the quick connect, while pushing the quick connect

upward onto the faucet adapter.

7. When the quick connect snaps onto the faucet adapter, release the

locking collar. Verify the connection is secure.

8. Slowly open the hot water line and check for any sign of water leaks at

all hose connections. If leaks are located, immediately turn off the water

supply and repair the hose connections.

IMPORTANT

1. Once you open the water supply line, (even if it is closed imme-

diately thereafter), the inlet hose will be pressurized.

2. To relieve water pressure from inside the inlet hose, first make

sure the water line (faucet) is closed, then press and hold the red

pressure relief button on the quick connect until the flow of water

stops.

WARNING

Failure to relieve water pressure before disconnecting the quick

connect from the faucet will result in back pressure over-spray.

The temperature of the incoming water can be very hot and can

cause severe burns and/or scalding.

DANGER

Do not let children disconnect the dishwasher. Close supervision

of children is always important around appliances.

NOTE: Hard water conditions will adversely affect the washing perform-

ance of your dishwasher. Hard water conditions will also contribute to

'lime' (white film substance) deposits and/or 'scaling' on the stainless steel

surface of the dishwasher tub and heater element, located in the sump

underneath the removable filter screen. To minimize these conditions, it is

recommended to operate/rinse the inside of the dishwasher (empty) using

1 cup of white vinegar once a week.

DISCONNECTING YOUR DISHWASHER

1. Shut off the water supply at the faucet.

2. Disconnect the power supply cord

3. Relieve water pressure

4. Pull down on the quick connect collar

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

Comments to this Manuals

No comments

Danby DDW621WDB Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Dishwashers Danby DDW621WDB