Danby DDW2405W Instruction Manual download pdf (Page 14)

OVERFLOW CONDITIONS:

The dishwasher is designed to detect/monitor water overflow conditions. The overflow tube is located in

the lower section of the inner door liner. This tube must be kept free and clear of obstructions and

debris. In the event of an overflow condition, the water level rises above the height of the overflow tube

and is directed into the overflow container.(located at the lower right side of the dishwasher) When the

water level reaches a predetermined height, the float switch is activated closing power to the water inlet

valve and automatically turns on the pump to evacuate the water inside the tub only. The accumulated

water inside the float container must be discharged manually before the dishwasher can be re-started.

To empty the float container, follow the instructions below.

Before you start;

• Disconnect the dishwasher from the

electrical power supply.

• Turn off the water supply using the shut-off

valve located next to the dishwasher or main

household shut-off valve.

• Remove the kick-plate.

• Disconnect the flexible (braid) hose

from the water inlet valve.

• The overflow container is located at the lower

right side of the dishwasher underneath the

insulation jacket. (

See Fig. 1

)

• Carefully slide out the dishwasher just

enough to access the overflow container,

approximately 12” (30.4 cm).

IMPORTANT: Keep the dishwasher

upright at all times.

To drain the overflow container;

1. Remove the rubber plug from the bottom

of the float container. (

See Fig. 2

)

2. Allow the water to drain into a cup or

container.

3. Replace the rubber plug, making sure

it is firmly secured.

4. Re-install the kick-plate.

5. Carefully slide the dishwasher back

into the cabinet.

The dishwasher is now ready to be restarted.

1 2 ... 9 10 11 12 13 14 15

No comments

Danby DDW2405W Instruction Manual Page 14