Danby DPAC10030 Owner's Manual download pdf (Page 20)

Air Conditioner Operating Instructions

(cont’d)

4) Press the FAN key to select the desired fan

speed setting (Auto-Low-Med-High). Your

selection will appear in the

display window

(each depression of the fan key will advance

to a different setting).

5) Press the

SWING key to activate the automatic

air swing (oscillating) feature (the “ ”

symbol will appear in the display window).

To deactivate the air swing feature, press the

SWING key again.

6) The horizontal louvers open and close

automatically when the unit is switched on

and off. To adjust “air flow” direction, (up / down

only) adjust the center louver only up or down

The blue indicator light will come on indicating the

air-conditioning mode is operational (there may be a

slight delay of 10-30 seconds before the cycle

begins, this is normal).

Cooling stops automatically when the set

temperature is achieved. Cooling resumes when the

room temperature rises above the set temperature

level. The temperature has no effect on the fan

operation. Therefore, the fan will operate

continuously (after the compressor has cycled off) to

maintain optimal temperature control.

Fig. 16

CAUTION

During air conditioning and dehumidifying modes, if the

compressor cycle is interupted (unplugged, power

failure,etc.) and reinstated immediately thereafter, (within

3-5 minutes) a “compressor protection circuit” is

automatically self-activated. The compressor cannot

operate during a “compressor protecton” condition. (this is

normal) It may take 3-5 minutes before the “protection

circuit” self-deactivates.

DO NOT ATTEMPT TO START THE UNIT

(COMPRESSOR) DURING THIS PERIOD.

Upon re-starting the unit (turn 1/0 switch on) all

program information(i.e. time, mode, fan speed, auto

timed programs) will have to be re-set.

ATTENTION

Removal and/or displacement of the internal water

tank will cause the compressor to stop operating

(this is a safety feature).

This condition will cause

the unit to beep (20 seconds) and the “water full”

(red) light will illuminate continuously until

corrected.

The compressor cannot operate

during a “red” light condition.

Check the following;

Is the internal water tank full?

Empty and re-install water tank.

Has the water tank been accidently displaced?

Re-position water tank.

The “red” light will turn off automatically when the

water tank has been emptied and/or re-positioned.

I/O

MODE FAN

SWING

RUN

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 64 65

Comments to this Manuals

No comments

Danby DPAC10030 Owner's Manual Page 20

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby DPAC10030