Danby DDR4509EE Operations Instructions download pdf (Page 7)

CONTROLS

Operating Instructions

6) POWER BUTTON

Press to turn the dehumidifier on and off.

7) Display

Shows the set % humidity level from 35% to 85% or auto start/stop time

(0~24) during setting, then shows the actual (± 5% accuracy) room %

humidity level in a range of 30% RH(Relative Humidity) to 90%RH

(Relative Humidity).

Error Codes and Protection Codes:

AS - Humidity sensor error--Unplug the unit and plug it back in. If error

repeats, call for service.

ES - Temperature sensor error-- Unplug the unit and plug it back in. If

error repeats, call for service.

P1 - Unit is defrosting-- Allow the unit time to automatically defrost. The

error will clear after the unit self defrosts.

P2 - Bucket is full or the bucket is not in right position--Empty the bucket

and replace in the right position.

E1 - unit malfunction -- Unplug the unit and plug it back in. If error repeats,

call for service.

INDICATOR

LIGHT FUNCTION

Power Light (Green):

the factory

default setting:

Humidity Setting: 60%

Fan Speed: High

IMPORTANT NOTE: Depending on the humidity conditions of the sur-

the “on/off” button is pressed (see dehumidifier operating instructions for

gram setting that was used when power is restored.

Water Full Indicator Light (Red):

This is

a safety feature. When the

water tank is emptied and/or correctly re-positioned, the dehumidifier will

resume operation automatically. NOTE: It may take several minutes before

operating conditions resume.

Memory Setting:

Each time the unit is disconnected/re-connected and/or in the event of a

power failure, the electronic circuit board automaticallydefaults to the last

program setting that was used. It may take several minutes before operat-

ing conditions resume.

NOTE: In the event of a power failure, all previous settings are automati-

cally erased/cancelled. If your program setting was different than above

(default setting) it will be necessary to re-program your settings. When the

unit is switched “off” manually (using the on/off keypad) the unit will always

default to the last program setting that was used.

When the water tank is full and/or incorrectly positioned inside the cabinet,

the (water full) red light turns on and remains on until such time the tank is

shut down of the compressor immediately and

fan motor operation

When the unit is first connected to an electrical outlet, the (green) power

light

turns on.

emptied and/or correctly re-positioned. This condition will result in the

shut down after 30 seconds.

to a state “on” condition. The dehumidifier will automatically default to

rounding environment, the dehumidifier may not start automatically when

ton is activated, the power light turns

details). In the event of a power failure, the unit will default to the last pro-

When the “on/off” but

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments

Danby DDR4509EE Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby DDR4509EE