Danby DDR4509EE Operations Instructions download pdf (Page 8)

Operating Instructions

WATER TANK

OPERATION

IMPORTANT

Never tamper with or attempt to defeat the water level (safety) float

switch system. Proper installation of the water tank is crucial to

maintaining reliable dehumidifier operation.

The water tank holds accumulated condensed water and by means of a

safety switch, controls both the water level and operation of the dehumidi-

fication process- i.e. When the water tank is full and/or accidentally

displaced inside the cabinet, the float switch actuator (inside the tank)

breaks contact with the safety switch. This condition results in the immedi-

ate shut down of the compressor and fan motor system, preventing

moisture from being condensed.

DEHUMIDIFYING

DEHUMIDIFYING is a means of removing moisture from the air. A dehu-

midifier will help to protect your home and valued possessions from dam-

age (swelling) caused by moisture in the air. Essentially a dehumidifier

removes moisture from air as moist air passes over a dehumidifying (evap-

orator) coil. Moisture is condensed on the evaporator coil, drained, and

collected inside an internal (removable) water tank located at the front of

the unit. The exhausted air being returned into the room environment is

elevated several degrees causing the surrounding air temperature to

increase (slightly). This process also contributes to lowering the relative

humidity of the surrounding air.

DEHUMIDIFYING MODE

INSTRUCTIONS

When the unit is first connected to the electrical outlet, the (green) power

light will be flashing until the “on/off” button is pressed.

When the “on/off” button is activated (pressed), the power light turns to a

state “on” condition and the dehumidifier automatically defaults to:

Display: Current Ambient Room Humidity (RH%)

Humidity Setting:60% RH

Fan Speed: High

IMPORTANT NOTE: Depending on humidity conditions of the surrounding

environment, the dehumidifier may not start automatically under the

default setting (this is an indication that the humidity level of the surround-

ing environment is lower than the “default” setting of 60% RH). Therefore,

it may be necessary to scroll through each of the different dehumidifier

settings 35% - 85% until the “humidstat” (sensor) recognizes conditions

that will allow the unit to operate.

DEHUMIDIFYING MODE SELECTION:

1) To turn the unit on press the ON/OFF button.

2a) Press the humidity “ + ” or “ - ” button to select a desired RH

operating value (35% -85%)

2b) Press the CONTINUOUS button. When CONTINUOUS mode is

selected, the humidistat (sensor) will be by-passed and the

compressor will operate non-stop regardless of humidity conditions.

FAN SPEED SELECTION:

3) Select a fan speed on the keypad. The speed you select is identified by

the (illuminated) indicator light located directly above the selection

made.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Comments to this Manuals

No comments

Danby DDR4509EE Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby DDR4509EE