Danby AAC5040 Specifications download pdf (Page 12)

Solving Common Problems

Explanation / Solution

◆ Check for a power failure.

◆ Check the voltage.

(See the technical specifications)

◆ Check the power plug for disconnection.

◆ Check to see whether the operating mode selection dial is placed in the

"Off" position. (Set it to the desired position.)

◆ Check to see whether the room temperature is too low.

- Refer to page 10 for details about temperature condition.

◆ Set the THERMOSTAT control to the desired position.

- When the number on the THERMOSTAT control is too high,

the room temperature may be too warm.

◆ Check to see whether there is an open window or leakage of cool

air to the outside.

- Close the window, and fill the gap.

◆ Check to see whether there is any obstacle adversely affecting

the flow of the air inside and outside the room.

- Remove the obstacle or change the position of the air conditioner.

◆ Check to see whether the air filter is clogged with dust or

contaminated with foreign substances.

- Clean the air filter.

◆ Check to see whether there is any direct sunlight facing the air conditioner.

- Block the sunlight with a sunshade.

◆ Check to see whether there is any electric device generating heat.

- Do not use the air conditioner together with any heating device.

◆

Ventilate the room.

Problem

The air conditioner

does not operate at all.

The air comes out smoothly,

but cooling is not effective.

Odors are permeating the

room during air conditioning.

Before contacting an authorized service center, perform the following simple checks.

They may save you the time and the expense of an unnecessary call.

E-

1 2 ... 7 8 9 10 11 12 13 14

No comments

Danby AAC5040 Specifications Page 12