Danby DWC276BLS Owner's Manual download pdf (Page 9)

Installation Instructions - Intergrated Application

Preparing the

Enclosure

FOR YOUR SAFETY:

While performing

installations described in

this section, gloves, safety

glasses or goggles should

be worn.

34-½" From

Underside of

Countertop to

Floor

Electrical Access

1-½" dia. hole

*If electrical

outlet is in

adjacent

cabinetry

12-½"

Tools You Will

Need

Carpenter’s

Square

Measuring

Tape

Level

Drill & Hole Saw set

Gloves

Safety Glasses

Flashlight

Electrical Requirements:

The appliance must be

connected to an individual

properly grounded electrical

outlet, protected by a 15 or

20 ampere circuit breaker or

time delay fuse.

Important: It is recommended

that you install the wine cooler in

a location that allows the door(s)

to have a greater then 45° open-

ing swing. A limited door swing

will prevent the shelves from

sliding out as intended, and may

lead to damaging the door gas-

ket(s).

• The rough cabinet opening

must be on a level floor area

and at least 24” deep* by 12-1/2”

wide.

The opening should also

have a height of at least 34-1/2”.

• The electrical outlet may be

positioned from within either

side of the adjacent cabinetry, or

the rear of the shaded area (as

shown in Fig C.).

Note: If the electrical outlet is

surface mounted (not flush) within

the enclosure, the

depth

requirment for the installation be

affected.

• If the electrical outlet is located

inside the adjacent cabinetry

, cut

a 1-1/2” diameter hole to admit

the power cord.

Fig C

*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja-

cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.

Philips

Screwdriver

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Comments to this Manuals

No comments

Danby DWC276BLS Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Wine coolers Danby DWC276BLS