Danby DTT100A1WDB User Manual download pdf (Page 7)

INSTALLATION INSTRUCTION

Place of installation

Choose a place on a horizontal solid floor. If the

machine is installed on an unstable floor, heavy

vibration will result during spin.

Keep the machine body more than 5 cm apart

from the wall surface. If it comes into contact

vibration may occur.

Hose Installation

For your convenience, this washing machine is

equipped with a “Quick Connect” hose kit.

Please follow these instructions:

1. Connect the “faucet adapter” to your water

supply

2. Pressure fit the open end of the hose

assembly at least half way down the “water

inlet” nipple. No clamps are required to secure

this connection because it is not a pressurized

line application.

3. Install the “quick connect” fitting to the faucet

adapter by pulling down the white collar. Pull

down on the white collar to disconnect.

4. For portable applications, avoid disconnecting

the water hose assembly from the “water inlet

nipple” connection. Always disconnect the

hose from the “quick connect” side. A “hanger

hook” is provided on the “quick connect” which

allows you to conveniently hang the hose on

the side of the cabinet.

Installing the drain hose

Install the drain hose properly as shown below.

Secure the drain hose to the drain outlet pipe,

using the clamp provided.

Faucet Adaptor

Quick connect

Water inlet nipple

Hook drain hose over the edge of sink or

directly into your drain pipe.

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

No comments

Danby DTT100A1WDB User Manual Page 7