Danby DFF092C1WDB Manual download pdf (Page 10)

TROUBLESHOOTING

Occasionally, a minor problem may arrise, and a service call may not be necessary- use this troubleshooting guide for a possible

solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free Number for assistance.

Tel: 1-800-26- (1-800-263-2629).

PROBLEM POSSIBLE CAUSE SOLUTION

1) Unit does not work.

• No power to unit.

• Power cord is unplugged.

• Wrong voltage is being used.

• Check connection of power cord at power

source.

• Plug in unit.

• Use proper voltage.

2) Refrigerator running too

frequently.

• Temperature control too high.

• Door not closed.

• Hot food inserted.

• Doors open too long/often.

• Close proximity to heat source or direct

sunlight.

• Adjust settings as needed.

• Close the door securely.

• Cool food before inserting.

• Minimize door openings/duration.

• DO NOT place unit close to heat sources or in

direct sunlight.

3) Internal temperature

too cold.

• Temperature control too high.

• Adjust settings as needed.

4) Internal temperature

not cold enough.

• No power to unit.

• Power cord is unplugged.

• Wrong voltage is being used.

• Temperature control too low.

• Hot food inserted.

• Doors open too long/often.

• Air flow obstruction.

• Close proximity to heat source or direct

sunlight.

• Check connection of power cord at power

source.

• Plug in unit.

• Use proper voltage.

• Check/adjust settings as needed.

• Cool food before inserting.

• Minimize door openings/duration.

• Allow room for air to circulate around the unit.

• DO NOT place unit close to heat sources or in

direct sunlight.

5) Freezer not cold enough.

• Temperature control too warm.

• Door not closed.

• Hot food inserted.

• Doors open too long/often.

• Wrong voltage is being used.

• Adjust settings as needed.

• Close door securely.

• Cool food before insterting.

• Minimize door openings/ duration.

• Use proper voltage.

6) Light will not work.

• No power to unit.

• Power cord is unplugged.

• Bulb is loose/needs replacing.

• Door switch is stuck.

• Check connection of power cord to power

source.

• Plug in unit.

• Tighten or replace bulb.

• Check the switch for obstructions, clean if

necessary.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Danby DFF092C1WDB Manual Page 10

Comments to this Manuals

Related products and manuals for Unknown Danby DFF092C1WDB