Danby DER202W Owner's Manual download pdf (Page 8)

INSTALLATION INSTRUCTIONS

To reduce the risk of the appliance tipping, the anti-

tip bracket must be installed before operation.

Note: The installation of the anti-tip bracket must

meet all local codes for securing the appliance.

The anti-tip bracket must be secured to either the

rear wall or the ﬂ oor and must be positioned in such

a way that it will overhang the anti-tip arm on the

rear of the appliance.

Rear wall installation

Use the two screws provided to secure the bracket

to the rear wall. The screws must enter a wood sill

plate. If the wall contains any metal studs or similar

materials, or if the back of the appliance cannot

reach the rear wall, the ﬂ oor installation should be

used.

Floor installation

Wood ﬂ oor: Use the two screws provided to secure

the bracket to the ﬂ oor.

Concrete ﬂ oor:

1. Mark the location where the screws need to be

installed.

2. Use a power drill and a concrete bit to drill a

5/32” pilot hole 2” deep into the concrete at the

center of each of the marked locations.

3. Use the two screws provided to secure the

bracket to the ﬂ oor.

Double check the installation

After installing the bracket, slide the appliance into

its ﬁ nal location. Look underneath the appliance

and ensure that the anti-tip arm attached to the side

panel of the appliance is engaging the bracket.

ANTI-TIP BRACKET INSTALLATION

1. Anti-tip arm on the back of the appliance

2. Anti-tip bracket

3. Screw must enter wood or concrete

4. Wall sill plate

5. Screw must enter wood

ELECTRICAL REQUIREMENTS

ALL NEW BRANCH CIRCUIT INSTALLATIONS,

MOBILE HOMES, RECREATIONAL VEHICLES AND

INSTALLATIONS WHERE LOCAL CODES DO NOT

ALLOW GROUNDING THROUGH NEUTRAL,

REQUIRE A 4-CONDUCTOR CORD OR CONDUIT

Use only a 3-conductor or a 4-conductor UL-listed

range cord. These cords may be provided with ring

terminals on wire and a strain relief device.

A range cord rated at 40 amps with 125/250

minimum volt range is required. A 50 amp range

cord is not recommended but if used, it should

be marked for use with nominal 1 3/8” diameter

connection openings. Care should be taken to

center the cable and strain relief within the knockout

hole to keep the edge from damaging the cable.

Because range terminals are not accessible after

the range is in position, a ﬂ exible service conduit or

cord must be used.

On some models, a ﬁ lter capacitor may be

connected between the black and white leads on the

junction block.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Comments to this Manuals

No comments

Danby DER202W Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Unknown Danby DER202W