Danby DBC047D3BSSPR Manual download pdf (Page 7)

LOCATION

Selecting the proper location will ensure peak performance levels for your appliance. Choose a location where the unit

will not be exposed to heat emitting sources (e.g. a ﬁ replace or a barbeque). The beverage centre should not be exposed

to direct sunlight. Do not use product near water, for example in a wet basement, near a swimming pool or sink.

NOTE: This unit is front breathing. Do not

block the front air vent. Blockage of the vent

will result in high operating temperatures and

system failure.

Installation Instructions

PREPARING THE ENCLOSURE

Tools you will need:

While performing installations described in this section, gloves and safety glasses or goggles should be worn.

Electrical Requirements:

The appliance must be connected to an individual, properly grounded electrical outlet, protected by a 15 or 20 ampere

circuit breaker or time delay fuse.

• It is recommended that you do not install the unit into a corner (i.e. directly beside a wall). This is to allow the door to

have a greater than 90° opening swing. A limited door swing may lead to damaging the door gasket, however, if it is

necessary to install the unit in a corner, be sure to allow 2-4 inches of clearance at each side.

• The rough cabinet opening must be on a level ﬂ oor area and at least 25” (63.5 cm) deep by 24” (60.96 cm) wide

(min). The opening should also have a height of at least 34 9/16” (86.8 cm).

• The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area

(as shown in Fig. 2).

• If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2” (3.81 cm) diameter hole to admit the power

cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.

Tape measure

Carpenter square

Electric drill with hole bit

Gloves

Level

Safety goggles

Flashlight

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Danby DBC047D3BSSPR Manual Page 7