Danby DAC12078EE Operations Instructions download pdf (Page 8)

REMOTE CONTROL

FEATURES

Electronic Display: Displays the following information;

A: Remote Control power On/Off and Mode Icons

B: Clock and Auto-Timer settings

C: Current set temperature

D: Fan speed setting Control Buttons

1) Power switch.

2) Mode

3) Fan Speed

4) Energy Saver

5) Auto-Timer

6) Used to increase or decrease temperature settings in 1°

increments on the Celsius scale.

7) Cancels current Timer ON/OFF settings.

8) Lock prevents the remote control settings from inadvertently

being changed.

9) Clock: Depress the button for 3 seconds in order to set the

clock. Press the increase or decrease arrow to adjust the clock in

1 minute intervals, holding down the increase or decrease arrow

will adjust the time in 10 minute intervals.

10) Used to activate the SLEEP program.

11) Toggle the LED backlight on/off.

12) Restore remote control default settings.

To operate the hand held remote control will require two “AAA” Alkaline batteries (included ).

Batteries should be replaced when:

a) No signal (beep) is heard when attempting to program the main unit.

b) The main unit does not respond to a command issued by the remote control.

Battery replacement:

1) Slide the rear cover on the remote in the direction of the arrow. Continue pulling (gently) until the cover

separates completely from the unit.

2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber

(+/-).

3) Re-install rear cover.

4) If the remote control will not be used for extended periods of time (vacations etc.), batteries should be

removed.

The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit.

Any obstruction between the receiver and remote may cause signal interference, limiting the ability to

program the main unit.

OPERATING INSTRUCTIONS (cont’d)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

No comments

Danby DAC12078EE Operations Instructions Page 8