Danby DAC 5209M Operations Instructions download pdf (Page 10)

PROBLEM POSSIBLE CAUSE SOLUTION

• Air conditioner will not

operate.

• Inefficient or no cooling.

• Noisy unit

• Odors

• Water dripping outside

• Water dripping inside

• Ice or frost build-up

• No power to the unit.

• Dirty air filter

• Unit size inappropriate for

application

• Blocked air flow

• Power interruption, settings

changed too quickly, or

compressor overload tripped.

• Loose parts

• Inadequate support

• Formation of mold, mildew, or

algae on wet surfaces.

• Hot and humid weather

• Unit is not properly angled to

allow water to drain outside

• Low outside temperature

• Unit air filter is dirty

• Check connection of power cord

to power source

• Check fuse or circuit breaker

• Set SELECTOR SWITCH to

position other than “OFF”

• The power cord “RESET” button

must always be pushed in

(engaged) for correct operation.

• Clean/replace air filter

• Check with dealer to determine

proper unit capacity for application

• Remove obstruction from grill or

outdoor louvres

• Turn the unit off and wait 5

minutes before attempting to

restart.

• Tighten loose parts

• Provide additional support to unit

• Clean unit thoroughly

• Place algaecide tablet in base pan

• Condensation run-off is normal

under these conditions

• Unit must be installed on an angle

for proper condensation run-off.

Check the unit and make any

adjustments.

• When outdoor temperature is

approximately 18.3°C (65°F) or

below, frost may form when unit is

in cooling mode. Switch unit to FAN

(only) operation until frost melts.

• Remove and clean filter.

Occasionally, a problem may occur that is minor, and a service call may not be necessary.

Use this troubleshooting guide for a possible solution. If the unit continues to operate

improperly, call an authorized service depot or Danby’s Toll Free Number for assistance:

1-800-26- (1-800-263-2629)

TROUBLESHOOTING

NOTES: 1) If circuit breaker is tripped repeatedly, or fuse is blown more than once, contact a

qualified technician

2) When unit is installed using proper installation steps, unit is properly tipped toward

the outdoors to allow for condensation run-off.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments

Danby DAC 5209M Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Mobile air conditioners Danby DAC 5209M