Danby DKC052BSLDB User Manual download pdf (Page 8)

Installation Instructions

ELECTRICAL

CONNECTION (cont)

This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical

outlet with three-prong ground receptacle. The cord should be secured

behind the Beer Dispenser and not left exposed or dangling to prevent

accidental injury.

Never unplug the Beer Dispenser by pulling the power cord. Always grip

the plug firmly and pull straight out from the receptacle.

CO2 GAS CAN BE DANGEROUS

CO2 cylinders contain high-pressure compressed gas which can

be hazardous if not handled properly. Make sure you READ and

UNDERSTAND the following procedures for CO2 cylinders

BEFORE INSTALLATION.

WARNING

1. ALWAYS connect the CO2 cylinder to a regulator. Failure to do so

could result in explosion with possible injury when the cylinder valve is

opened.

2. NEVER connect the CO2 cylinder directly to the keg.

3. ALWAYS follow correct procedures when cylinders are changed as per

local codes.

4. ALWAYS secure the CO2 cylinder in an upright position.

5. NEVER drop or throw a CO2 cylinder.

6. ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in

a cool place (preferably 70°F). Securely fasten with a chain in an

upright position when storing.

7. ALWAYS ventilate and leave the area immediately if CO2 leakage has

occurred.

8. ALWAYS check the D.O.T. test date on the cylinder neck before

installation. If over five (5) years, do not use, return cylinder to gas

supplier.

9. NEVER connect a keg without a safety pressure release.

a. One at or on the CO2 regulator

b. One at or on the product coupler or in the pressure gas line.

Beer Keg Installation Instructions

CO2 TANK

COLOURED PRESSURE HOSE

KEG

AMERICAN

SANKEY TAP (COUPLER)

CLEAR HOSE

WITH WING NUT

TOWER

FAUCET ASSEMBLY

SINGLE GAUGE

PRESSURE

REGULATOR

TOWER

Keg Installation Sketch

 Install the four castors (2 locking castors at front) into the unit’s bottom

(four screw holes pre-supplied) Figure (1) before installation. Figure (II)

is the final version. Put the metal washers provided on the front castors

before installing them.

METAL

WASHERS

Figure 1

Figure 2

CASTORS

Put metal washers

on the front castors.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 44 45

Comments to this Manuals

No comments

Danby DKC052BSLDB User Manual Page 8

Comments to this Manuals

Related products and manuals for Fridges Danby DKC052BSLDB