Danby DFF1044W/BLS Owner's Manual download pdf (Page 3)

CAUTION: To avoid personalInjury to yourself and/or

property, we recommend someone assist you dur|ng

the door reversal process,

1. To access the lower hinge assembly, tilt beck the

refrigerator cabinet or lay the refrigerator on its back.

(Fig, A)

2, Remove both leveling legs located at the fronl of the

cabtnel

3, Remove the screws holding the lower hinge assembly

to Iha cabinet. (Fig A)

4, Remove the freezer door assembly from the

refdgeratar cabinet, (open door and pufl down)

5, Remove the worktop to access and disconnect the

wiring harness connectors (2) from the control panel

wiring, (Fig B)

6. Remove the screws from the mtddle hinge assembry

Then remove the hinge end main door,

7, Remove (unscrew) the top hinge pln. (Fig, D)

8, Rednstall the fresh food door lop hinge pln on the

opposite side of the cabinet, (Fig D)

9, Remove the door plugs and door bushings located on

the top and bottom of each door assembly,

10. insert the detached control panel connectors into

the cavity (where the bushing was removed) on the

right side of the trash food door_

11. Extract the left side control panel connectors from

the left side cavity (where the plug was removed) of

the fresh food door and reconnect to the matn wtdng

harness - while to white, black to bieck

12, Re-Install worktop,

13, Interchange poslUons of plugs and bushings on both

doors, (is door pfug right side, door bushing left side)

14. Re,install main door assembly on cabinet,

15. Re.thstall the middle hinge assembly on the

opposite side, (Fig C)

16. Make sure the door assembly isproperly aUgned on

the cabinet, before tightening hinge screws

17. Rednetall freezer door assembly on cabinet.

18. Re-tnstaU the lower hinge assembly on the opposite

side_ Making sure to change bushing and screw on

oppostta sides on bottom ot unit

19. Make sure the door assembly ts properly aligned on

the cabinet, before lightening lower hinge sorews_

20. Rs-thstall both leveling legs,

The process is now complete,

Fig, ,;.....

To replace the refrigerator Ilght bulbs;

1, Remove the lop two shelves from the cabinet°

2, Remove the screw from the upper portion of the

light bulb cover,

3. Pull the iIghl bulb cover outward to remove ]t_

4, Unscrew the bulb(s),

5- Replace with a 120V/15 Watt bulb onlF

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Danby DFF1044W/BLS Owner's Manual Page 3

Comments to this Manuals

Related products and manuals for Fridges Danby DFF1044W/BLS