Danby DBC128BLS Owner's Manual download pdf (Page 9)

Installation Instructions - Door Swing Reversal

1. Unplug the unit from the electrical outlet (if con-

nected) and lay it on it’s back.

2. Remove the screws from the lower hinge assembly as

shown in Figure F.

Pull the door downward to remove it from the

cabinet of the Beverage Center.

4. Remove the cap from the top left side of the

door (Fig G) and reinstall it on the top right side.

5. Remove the three (3) screws supporting the

top hinge (Fig H).

6. Remove the plastic caps from the left side of

the frame (Fig I) and reinstall them on the right

side of the frame (the previous hinge location).

9. Install the upper hinge assembly on the left

side of the frame.

10. Carefully reposition the door firstly into the

upper hinge assembly then onto the cabinet.

11. While the door remains closed install the

lower hinge assembly.

12. Close the door and return the unit into it’s

upright position (wait 60 mins before re-connect-

ing power to the beverage center), verify the

door alignment and proper seal against the cabi-

net.

FIG I

Plastic Caps (2)

Upper Hinge

FIG G

Door Plug

Lower Hinge Assembly

and Door Support Bracket

FIG F

FIG H

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Danby DBC128BLS Owner's Manual Page 9