Danby DFF100C2WDD Manual download pdf (Page 8)

Installation Instructions

Please follow the steps below

We recommend that you start by unplugging your refrigerator unit.

1. Take off the light cover by flicking the bottom tab up (the bottom tab is located at the bottom middle of the

light cover).

2. Take out the LED display by pulling it down and unhooking it from the port, it is best to use your thumb on

the front of the LED and you fingers at the back near the port.

3. Put in the new LED by inserting it into the port.

4. Once the LED is secured, put the cover back on by inserting the two top tabs in to their slots and pushing

the bottom tab back into place, you should hear a quiet click.

Once you have secured the light cover back on, you can plug your refrigerator back in.

Take off the light cover by

flicking up bottom tab

You will see the LED display

Unhook the LED display

using your thumb and fingers

Hook the new LED display to the

port

Bottom tab

Pull the LED display down

Top tabs

Put the cover

back on

CHANGING LED LIGHT

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

No comments

Danby DFF100C2WDD Manual Page 8