Danby DAR194W Operations Instructions download pdf (Page 11)

Trouble.Shooting

Sometimes you may come across minor problems

that in most cases do not require a service call and

can be easily eliminated. The problem may have

resulted from improper handling and/or installation of

the appliance. Please refer to the below trouble-

shooting guide to assist you in identifying the

possible cause and solution to your problem. Should

the problem still persist after completing these

checkpoints. Contact the closest authorized service

agent in your area for assistance.

The Appliance Fails to

Operate After Connecting to

Electrical Power Supply

* Check the power cord is properly connected.

. Check the power supply in the electrical outlet.

(blown fuse / circuit breaker)

. Make sure the appliance is switched on.

(thermostat knob in operating position)

Continuous Operation of the

Cooling System

* The door is frequently opened or left open for

too long.

. The door is not properly closed (the door may sag,

the gasket may be polluted or damaged).

. Perhaps you may have overloaded the appliance

with fresh foods.

. The reason may be inadequate ventilation of the

compressor (assure adequate air circulation).

ice Formation on the inner

Rear Wall

As long as the defrost water runs to the channel and

through the outlet to the drain pan on the

compressor, automatic defrosting of the appliance

is assured.

In case the ice formation on the inner back wall is

increased (3-5 mm), ice should be manually

defrosted.

Set the thermostat knob to STOP (0) position and

leave the door open. Never use electric devices for

defrosting and do not scrape the ice or frost layer

with sharp objects.

increased ice formation may be one of the following:

the door does not seat well (clean the gasket if it is

contaminated, or replace it if it is damaged);

-the door is frequently opened or left too long;

-the food stored in the refrigerator was warm;

-the food or dish is touching the inner back watt.

Water is Leaking From the

Refrigerator

If the discharge water outlet is clogged, or the

defrost water drips over the channel, water wilt leak

from the refrigerator.

• Clean the clogged outlet, for example with a

plastic straw.

• Manually defrost the increased ice layer. See

"Ice Formation on the Inner rear Wall"

Noise

Cooling in a refrigerator-freezing appliance is made

possible by cooling the system using a compressor,

which will produce certain noise levels. How noisy

the appliance is depends on where it is placed, how it

is used and how old the appliance is.

• During the operation of the compressor the

noise of the liquid is heard and when the compressor

is not operating, the refrigerant flow is heard. This is

a normal condition and it has no influence

whatsoever on the lifetime of the appliance.

• After starting the appliance, the operation of

the compressor and the refrigerant flow may be

louder, which does not mean that something is wrong

with the appliance and it has no influence on the

lifetime of the appliance. Gradually the is noise

reduced.

• Sometimes unusual and louder noise is heard,

which is rather unusual for the appliance. This noise

is often a consequence of inadequate installation.

-The appliance must be level and installed on a firm

solid base/floor.

-It should not touch the wall or kitchen units standing

next to it.

-Check the accessories on the interior of the

appliance, they should be placed correctly in their

positions; also check, bottles, tins, and other vessels

are not touching each other causing rattling

and/or vibrations.

After defrosting is complete, turn the knob to desired

position and close the refrigerator door.The cause of

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Comments to this Manuals

No comments

Danby DAR194W Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Drink coolers Danby DAR194W