Danby DDR45A3GDB Operations Instructions download pdf (Page 9)

The water tank should be carefully removed from the machine by sliding it outward from the

front of the unit, and it should be emptied. When the empty tank is replaced properly in the

machine, the unit will start up and run normally (Fig. 2).

NOTE: Please use both hands to carefully empty the water tank.

OPERATING INSTRUCTIONS

WATER FULL

INDICATOR LIGHT (RED)

When the bucket is full and/or incorrectly positioned inside the cabinet, the water full red light turns on and remains on

until such time as the bucket is emptied and/or correctly re-positioned. This condition will result in the immediate shut

down of the dehumidifying system (both compressor and fan motor operation are terminated). This is a safety feature.

When the bucket is emptied and/or correctly re-positioned, the dehumidiﬁ er will resume operation automatically.

NOTE: It may take several minutes before operating conditions resume.

DEHUMIDIFYING

Dehumidifying is a means of removing moisture from the air. A dehumidiﬁ er will help to protect your home and valued

possessions from damage (swelling) caused by moisture in the air. Essentially a dehumidiﬁ er removes moisture from the

air as the moist air passes over a dehumidifying (evaporator) coil. Moisture is condensed on the evaporator coil, drained,

and collected inside an internal (removable) water tank located at the front of the unit. The exhausted air being returned

into the room environment is elevated several degrees, causing the surrounding air temperature to increase

(slightly). This process also contributes to lowering the relative humidity of the surrounding air.

DEHUMIDIFYING MODE SELECTION:

1) To turn the unit on, press the ON / OFF button.

2) Press the humidity

or buttons to select a desired RH operating value (30%-90%).

FAN SPEED SELECTION:

Select a fan speed on the keypad. The speed you select is identiﬁ ed by the (illuminated) indicator light located directly

above the selection made.

1. Place the product in an upright position on a ﬂ at, stable, and heat-resistant

surface. Make sure there is nothing ﬂ ammable or heat sensitive within 39

inches (100 cm). Operating the product in any other position could cause a

hazard.

2. Insert the plug into a suitable wall socket. The dehumidiﬁ er is suitable for

operating on an electricity supply having the same voltage as that shown on its

rating label.

3. Make sure the water tank is correctly positioned. After switching the unit on for

the ﬁ rst time, if the ``Bucket Full`` light illuminates, pull out the water tank and

check that the ``ﬂ oat`` lever is able to move freely. Then return the water tank

to the correct position (Fig. 1).

START OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

No comments

Danby DDR45A3GDB Operations Instructions Page 9