Danby DPA140HB1WDD User Manual download pdf (Page 4)

Model

Rated Voltage

Remote Control Specifications

2. Timer Setting Function in 24 hours.

3. Indoor Setting Temperature Range: 17°C ~30°C (62°F~86°F).

4. Full Function of LCD (Liquid Crystal Display)

Environment

Signal Receiving Range

Performance Feature

CAUTION

Do not mix old and new batteries or batteries of dif

ferent types.

Do not leave the batteries in the remote controller if it is not going

to be used for more than 2 months.

Dispose of the old batteries in special containers such as those

found

in the sales outlets.

NOTE:

All the illustrations in this manual are for explanatory purposes only.

Your air conditioner may be

NOTE :

3.0V(

2-AAA

)

1. Operating Mode: AUTO, COO

L, DR Y,

and FAN.

RG 51I46/ BGE

-5°C to 60°C (-41°F to 140°F)

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

1) Reorient or relocate the receiving antenna

2) Increase the separation between the equipment and receiver

3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

4) Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not approved by the party responsible for FCC compliance could void the user’s

authority to operate the equipment.

This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired

operation.

CAN ICES-3 (B) / NMB-3 (B)

Temperature setting display: press and hold the UP and DOWN buttons at the same time for

3 seconds to alternate the temperature display between °C and °F.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Danby DPA140HB1WDD User Manual Page 4

Comments to this Manuals

Related products and manuals for Conditioners Danby DPA140HB1WDD