Danby DPA120B3WDB User Manual download pdf (Page 16)

Remove the

upper drain

plug

Continuous

drain hose

Installation Instructions

WATER DRAINAGE

• During dehumidifying modes, remove the upper drain plug from the

back of the unit, install the drain connector (5/8” universal female con-

necter) with 3/4” hose (not included). For the models without a drain con-

nector, just attach the drain hose to the hole. Place the open end of the

hose directly over the drain area in your basement floor. Please refer to

Fig.22.

During heating pump mode, remove the lower drain plug from the back of

the unit, install the drain connector(5/8 universal female connector) with

3/4 hose (not included). For the models without drain connector, just

attach the drain hose to the hole. Place the open end of the hose directly

over the drain area in your basement floor. Please refer to Fig.23.

• When the water level of the bottom tray reaches a predetermined level,

the unit beeps 8 times, the digital display area shows P1. At this time

the air conditioning/dehumidification process will immediately stop.

However, the fan motor will continue to operate (this is normal).

Carefully move the unit to a drain location, remove the bottom drain plug

and let the water drain away (Fig.24). Restart the machine until the P1

symbol disappears. If the error repeats, call for service.

NOTE: When operating or draining water always protect carpeting or

floors from possible water spillage.

NOTE: Be sure to reinstall the bottom drain plug before using the unit.

Fig.22

Fig.23

Fig.24

Continuous

drain hose

Remove the

lower drain

plug

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Danby DPA120B3WDB User Manual Page 16