Danby DPA100B2WDB User Manual download pdf (Page 18)

Troubleshooting

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-

bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or

Danby’s Toll Free Number 1-800-263-2629 for assistance.

Unit does not start

when pressing on/off

button

• P1 appears in the display window

• Room temperature is lower than

the set temperature. (Cooling mode)

• Drain the water in the bottom tray.

• Reset the temperature.

Not cool enough

• The windows or doors in the room

are not closed.

• There are heat sources inside the

room.

• Exhaust air hose is not connected or

blocked.

• Temperature setting is too high.

• Air filter is blocked by dust.

• Make sure all the windows and

doors are closed.

• Remove the heat sources if possible.

• Connect the hose and make sure it

can function properly.

• Decrease the set temperature.

• Clean the air filter.

PROBLEM

POSSIBLE CAUSE

SOLUTION

Noisy or vibration

• The ground is not level or not flat

enough.

• Place the unit on a flat, level ground

if possible.

Gurgling sound

• The sound comes from the flowing

of the refrigerant inside the

air conditioner

• It is normal

Power shuts off in

heating mode

• The automatic overheat protection

function. When the temperature at the

air outlet exceeds 70°C/158°F, the

device will stop.

• Turn on again after the unit

has cooled down. Reduce

temperature setting.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments

Danby DPA100B2WDB User Manual Page 18

Comments to this Manuals

Related products and manuals for Conditioners Danby DPA100B2WDB