Danby AAC080EB1G User Manual download pdf (Page 13)

Operating Instructions

USING THE REMOTE

CONTROLLER

BUTTONS

1

ON/OFF

MODE

TEMP

UP

TEMP

DOWN

SWING

TIMER

SLEEP

FAN

SWING OPERATION

Use the SWING button to adjust the

Left/Right airflow direction.

1) Press this button while the unit is

operational, the vertical louvers

automatically swing right and left

sweeping the cold/hot air alternately to

obtain comfortable cooling/heating.

2) Press the SWING button again to stop

the swing operation.

1

ON/OFF

MODE

TEMP

UP

TEMP

DOWN

ENERGY

TIMER

CLEAN

AIR

SLEEP

S

SAVER

FAN

SLEEP OPERATION

• In this mode, the selected temperature

will increase(in cooling mode) / decrease

(in heating mode) by 2°F 30 minutes after

the mode is selected.

• The temperature will then increase by

another 2°F after an additional 30

minutes.

• This new temperature will be maintained

for 7 hours before it returns to the

originally selected temperature. This ends

the Sleep mode and the unit will continue

to operate as originally programmed.

• The Sleep mode program can be

cancelled at any time during operation

by again pressing the Sleep button.

1

ON/OFF

MODE

TEMP

UP

TEMP

DOWN

ENERGY

TIMER

CLEAN

AIR

SLEEP

S

SAVER

FAN

TIMER OPERATION

press the TIMER button can set the Auto-

start and Auto-stop time of the unit.

NOTE:

• To set Auto-start time, the unit must be in

the OFF position.

• To set Auto-stop time, the unit must be in

the ON postion.

To set the Auto-start time.

1. Push the TIMER button when the unit is

off, only the Auto-start feature can be set.

2. Keep pressing the TIMER button, each

press will increase the selected time by

1 hour increments, up to 12 hours.

3. The time can be set in a range of 0~12

hours.

4. After the desired time has established,

wait for about 10 seconds until the

setting temperature reverts back in the

display window of the air conditioner.

This indicates the program is set.

12

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Comments to this Manuals

No comments