Danby DAC100EB2GDB Operations Instructions download pdf (Page 16)

Operating

Instructions

CHANGING THE

BATTERIES ON THE

REMOTE

`oOMO R

oOMO R

The remote controller is powered by

one button cell housed in the rear part

and protected by a cover. Remove the

button cell according to the arrow

marked at the back of the remote

controller.

1. Slightly press “A” position

according to the number 1

arrow direction by your

forefinger.

2. Press “B” position and pull it

according to the number 2

arrow direction by your

thumb.

3. The above step 1 and 2

should be done simultaneously

to slide the button cell out.

Protect the remote control from high

temperatures, and keep it away from

radiation exposure.

Keep the control panel receiver out of

direct sunlight.

If the remote control will not be used for

extended periods of time (vacations etc.),

batteries should be removed.

This Class B digital apparatus complies with

the Canadian ICES-003 standard. CAN ICES-3 (B)

The remote operates within a range of 8

meters (26 ft.) from the receiver located

inside the main unit.Any obstruction between

the receiver and remote may cause signal

interference, limiting the ability to program

the main unit.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

--Reorient or relocate the receiving antenna

--Increase the separation between the equipment and receiver

--Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected

--Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not approved by the party responsible for FCC compliance could void the

user’s authority to operate the equipment.

This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause

undesired operation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Danby DAC100EB2GDB Operations Instructions Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DAC100EB2GDB