Danby D1866WE User Manual download pdf (Page 4)

Removing Packaging Materials

• Remove tape and any labels from your refrigerator

before using (except the model and serial number label).

Do not remove any permanent instruction labels.

To remove any remaining tape or glue, rub the area

briskly with your thumb. Tape or glue residue can also

be easily removed by rubbing a small amount of liquid

dish soap over the adhesive with your fingers. Wipe with

warm water and dry.

• Do not use sharp instruments, rubbing alcohol, flam-

mable fluids, or abrasive cleaners to remove tape or

glue. These products can damage the surface of your

refrigerator. For more information, see “Important Safety

Instructions” in the “Refrigerator Safety” section.

• Do not install the refrigerator near an oven, radiator,

or other heat source, not in a location where the

temperature will fall below 40°F (5°C).

Note: Some shelf trim comes with a protective

film. Look for the “Peel Off” strip to remove this

protective film.

INSTALLING YOUR

REFRIGERATOR

Unpacking Your Refrigerator

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

• To ensure proper ventilation for your refrigerator, allow for a

1” (2.5 cm) space on each side.

• Allow 3”” (7.5 cm) of space between overhead cabinets

and refrigerator top.

• Allow at least 1” (2.5 cm) between back of cabinet and the

wall.

• If the hinge side of the refrigerator is to be against a wall,

you might want to leave extra space so the door

can swing open.

Space Requirements

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion

or fire.

WARNING

1 in./po. min

(2.54 cm)

3 in./po. min (7.5 cm)

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Danby D1866WE User Manual Page 4

Comments to this Manuals

Related products and manuals for Refrigerators Danby D1866WE