Danby DPA140HEAUWDB Manual and User Guide download pdf (Page 10)

OPERATING INSTRUCTIONS

REPLACING THE REMOTE BATTERIES

The remote control will arrive with a CR2025 coin

battery pre-installed. It may be necessary to remove

a clear, plastic insulating strip before ﬁ rst use of the

remote control.

Follow the steps below to replace the battery.

1. Use a screwdriver to remove the screw that

secures the battery cover.

2. Push the battery cover hook to the right to

release it from the remote control. Pull the

battery cover out.

IMPORTANT

Do not dispose of

batteries as unsorted

municipal waste. Refer

to local laws for proper

disposal of batteries.

Notes:

• The air conditioner will not respond if curtains,

doors or other materials block the signal from

the remote control to the appliance.

• If the infrared signal receiver on the indoor unit

is exposed to direct sunlight, the air conditioner

may not function properly. Use curtains to

prevent the sunlight from falling on the receiver.

• Do not allow the remote control to get wet.

• Do not expose the remote control to direct

sunlight or heat.

• Do not leave the battery in the remote control

if it is not going to be used for more than 2

months.

WATER DRAINAGE

When the internal drain pan becomes full the

appliance will beep 8 times and the digital display

will show error code P1. The air conditioning or

dehumidifying action will stop but the fan may

continue to operate.

Follow the steps below to drain the appliance.

1. Turn the appliance off and unplug it from the

power source.

2. Carefully move the appliance to a location

where the water can be drained.

3. Remove the drain plug and allow the water to

completely drain.

4. Replace the bottom drain plug, pressing ﬁ rmly to

ensure a tight ﬁ t and no leaks.

5. The P1 error symbol will disappear and the

appliance will resume regular function once

power is restored.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

Danby DPA140HEAUWDB Manual and User Guide Page 10

Comments to this Manuals