Danby DMW111KPSSDD Owner's Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
SETTING
THE CLOCK
8
1) Press “CLOCK” pad.
2) Press the number keys and enter the current time.
For example, to set 12:10, press “1, 2, 1, 0” in
turn.
3) Press “CLOCK” again to finish clock setting.
NOTES:
• When the microwave is first plugged in, or when
power resumes after a power interruption, the display
will show ENTER CLOCK TIME. If you prefer not
to have the clock displayed, touch RESET.
You can check the clock time while cooking is in
progress by touching the CLOCK pad.
SETTING THE
KITCHEN TIMER
1) Press “TIMER” pad.
2) Press the number keys and enter the timer time (the
maximum cooking time is 99 minutes and 99
seconds).
3) Press “START/STOP.” to confirm the setting.
NOTES:
• Timer countdown can be seen in the display before
the clock or cooking time is returned to the display.
• Touch TIMER and then RESET to cancel the
Timer during timing process.
Your microwave clock is a 12-hour system.
MICROWAVE
COOKING
SETTING A COOKING PROGRAM:
A) One-Stage Cooking.
1) Use the number pads to set a cooking time. You
can set a cooking time from one second to 99 minutes
and 99 seconds.
2) If you want to set a power level other than 100%
power, touch POWER LEVEL and then use the
number pads to enter the power level desired.
3) Touch START/STOP to start cooking.
B) Two-Stage Cooking.
1) Set STAGE 1: Follow steps 1 and 2 in “One-
Stage Cooking”. DO NOT touch START/STOP.
2) Set STAGE 2: Touch COOK, then enter desired
cooking time and power level. Most two-stage
recipes use lower power for the second stage.
3) Touch START/STOP.
NOTE: After total time has elapsed, signal sounds
and END appears in the display. Touch any pad or
open the microwave oven door to clear END before
starting another cooking function.
USE THESE SINGLE DIGITS TO
REPRESENT POWER LEVELS:
Number % of Power
9 90%
8 80%
7 70%
6 60%
5 50%
4 40%
3 30%
2 20%
1 10%
OPERATION
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments