Danby DUFM320WDD User Manual download pdf (Page 2)

IMPORTANT SAFETY INFORMATION

ELECTRICAL

REQUIREMENTS

INSTALLATION

OPERATION

To avoid vibration, the cabinet must be set level.This is accomplished by adjusting

the (2) front leveling legs located under the freezer cabinet. To start the freezer, turn

the temperature control to the position corresponding to the desired cooling.

0 = No Cooling 1= Minimum Cooling

3, 4 = Medium Cooling MAX= Maximum Cooling

The freezer temperature will vary depending on the quantity of the food stored and

on the frequency with which the door is opened.

This appliance must be grounded. In the event of an electrical short circuit, grounding

reduces the risk of electrical shock by providing an escape wire for the electrical current.

DEFROSTING

INSTRUCTIONS

This appliance is equipped with a cord having a

grounding wire with a grounding plug. The plug

must be plugged into an outlet that is properly

installed and grounded.

IMPORTANT WARNING

An empty refrigerator can pose a threat to children.

To render the unit harmless we strongly recommend

removing the door prior to disposal.

WARNING - Improper use of the grounding plug can

result in a risk of electric shock. Consult a qualified

electrician or serviceman if the grounding instructions

are not completely understood, or if doubt exists as to

whether the appliance is properly grounded.

DO NOT USE AN EXTENSION CORD

Use an exclusive wall outlet. Do not connect your

refrigerator to extension cords or together with any

other appliance in the same wall outlet.

Remove exterior and interior packings, wipe the

outside thoroughly with a soft dry cloth and the inside

with a wet, lukewarm cloth. Avoid placing the cabinet

in a narrow recess or near any heat source, direct

sunlight, or moisture. Let air circulate freely around

the cabinet. Keep the rear of the freezer 5 inches

away from the wall.

Location:

1) Select a place with a strong, level floor.

2) Allow 5 inches of space between the back of the

freezer and any adjacent wall.

3) Avoid direct sunlight and heat. Direct sunlight may

affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

4) Avoid very moist places. Too much moisture in the

air will cause frost to form very quickly on the

evaporator, and your freezer will have to be defrosted

more frequently.

1) Turn temperature control to ‘0’(off) and unplug

power cord.

2) Remove all frozen food.Wrap frozen food in

several layers of newspaper and cover with a blanket.

Food will say frozen for several hours OR store

frozen food in a cooler, additional refrigerator-freezer

or in a cool area.

3) Place pans of hot water in freezer with door open

to speed melting. Directing air from an electric fan

into freezer will also help. Do not place fan in freezer.

4) Remove frost.

5) Wipe water from walls and bottom of freezer with

a towel or sponge.

6) Wash inside walls.

7) Rinse and dry thoroughly.

8) Replace all frozen food.

9) Plug in power cord and refer to “Operation.”

Defrost and clean your freezer when frost has built up to about 1 1/4”(6mm) thickness.

Complete defrosting and cleaning should be done at least once a year. In high humidity

areas, a freezer may need more frequent defrosting and cleaning.

IMPORTANT: Do not use an ice pick, knife or other sharp-pointed tool to defrost freezer. Damage can occur.

Maximum cooling

1 2 3 4 5 6 7 ... 13 14

Comments to this Manuals

No comments

Danby DUFM320WDD User Manual Page 2

Comments to this Manuals

Related products and manuals for Freezers Danby DUFM320WDD