Danby DPAC10030 User Manual download pdf (Page 40)

Care and Maintenance

1) Do Not use gasoline, benzene, thinner or any

other chemicals to clean this unit ,as these

substances may cause damage to the finish and

deformation of plastic parts.

2) Never attempt to clean the unit by pouring water

directly over any of the surface areas, as this will

cause deterioration of electrical components and

wiring insulation.

Removal and Cleaning of the Air Filter

If the air filter becomes clogged with dust/dirt, air

flow is restricted and reduces cooling efficiency. The

air filter should be cleaned every two (2) weeks.

More frequent cleaning may be necessary

depending upon indoor air quality. NOTE: The air

filter is located at the (upper) rear side of the unit.

1) To remove the air filter: Pull the air filter upward

in the direction of the arrow.

2) Dust/Dirt clogged in the filter can be removed by

vacuum cleaning the soiled areas.

4) The filter can also be washed in lukewarm soapy

water while rubbing it lightly with a brush. A mild

detergent (dishwashing soap) is recommended.

5) Rinse the filter well using clean water. Allow time

to dry before reinstalling into the unit.

6) Replace the air filter

7) Replacement air filters are available through the

Customer Service Parts Department.

CAUTION

Never operate the unit without the air filter in place

as this may result in damage to the unit.

CAUTION

Before cleaning or servicing this unit, it is

recommended that the unit be disconnected from

any electrical supply outlet.

Air Filter

Tab

Fig. 34

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 64 65

No comments

Danby DPAC10030 User Manual Page 40