Danby DKC445BL Service Manual download pdf (Page 11)

Keep a thermometer handy. (adjust temperature control knob accordingly)

Periodically monitor temperatures inside your cooler. (adjust as necessary)

Keep the refrigerator door closed as much as possible to avoid temperature fluctuations

AUTOMATIC DEFROSTING:

There is no need to defrost the refrigerator, because ice depositing on the evaporator is defrosted automat-

ically. Ice build-up on the evaporator during compressor operation; will (when the compressor has cycled

off) defrost automatically. Defrost water collects inside the drain trough and passes through the drain outlet

in the rear wall into a drain pan situated above the compressor, where it evaporates.

CLEANING THE APPLIANCE:

Always disconnect the power cord before cleaning and/or servicing the appliance. Do not use coarse or

aggressive cleaning agents as they can damage painted surfaces. Clean the exterior cabinet with warm

water and a mild detergent. Clean the interior with warm water and a mild detergent, adding one or two

spoonfuls of vinegar. After cleaning, connect the appliance to power supply.

SWITCH OFF AND/OR DISCONNECT THE APPLIANCE WHEN NOT IN USE:

If you do not intend to use the appliance for long periods of time, (vacations) set the thermostat knob to the

"0" (off) position and disconnect the power cord. Take out all foods and clean the appliance. Leave the

door slightly open to reduce mold/mildew from accumulating inside the cabinet.

If you find the direction of the door swing on your appliance inconvenient, you can change it to the

opposite side. Simply follow the steps listed below.

10.

11.

12.

13.

14.

Lay the unit on it's back.

Remove the adjustable leveling leg from the lower right hinge.

Remove two (2) screws from the lower door hinge.

Open the main door and pull down, until the door releases from the upper door hinge pin.

Remove the plastic door plug (cap) from the top left side of the main door.

Re-install plastic door plug (cap) to the top right side of the main door

Remove (unscrew) the upper door hinge pin. (right side cabinet)

Re-install the upper door hinge pin. (left side cabinet)

Position the main door back on the cabinet and push up until the top hinge pin is inserted

into the top of the door.

Re-install the lower door hinge to the left side of the cabinet, using the same screws

removed earlier.

Align the main door on the cabinet before tightening the lower hinge screws.

Re-install the leveling leg back into the lower hinge.

Return the unit back to the upright position.

Allow the unit to stand 30 minutes before switching the unit on.

1 2 ... 6 7 8 9 10 11 12 13 14 15

No comments

Danby DKC445BL Service Manual Page 11