Danby DWM5500W User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 27
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
TROUBLE SHOOTING
FAILURE DETECTION AND REPAIR
General: Always handle the machine highly professionally. Tests and failure
detection should be made systematically and in the prescribed order.
Always use original wiring diagrams, drawings and timetables.
If a failure is not a typical one and you will have to test the washing machine, check
the following first:
is the washing machine connected to a power supply (the voltage should
correspond to the one stated on the rating plate)
is water pressure within the required limits (0,5 - 8 bar)
is the water outlet hose correctly located (the height of the hose is 50-100 cm)
are transport brackets removed and the machine properly levelled
Problem Possible cause Remedy
Machine does not
operate
Machine door open
Electric valve out of order
Door interlock damaged
Blocked sieve at the
entrance of the el. valve
Replace damaged
component, remove the
cause
Machine accepts water
above the foreseen level
Pressure switch tube,
pressure switch system
blocked
Pressure switch tube
leaking
Pressure switch does not
switch over
El. valve damaged
Water flowing into the
machine continuously
(pressure of water less
then 0.5 bar, electric
valve does not closing)
Replace damaged
component, remove the
cause
Machine does not heating Heater interrupted
Interruption of the cable
set
Replace damaged
component, remove the
cause
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Comments to this Manuals

No comments