Danby DWM045WDB User Manual download pdf (Page 9)

CONNECTING THE WATER SUPPLY HOSE

Installation Instructions

Connect the water inlet hose to the connector by turning

the connecting nut. Be sure a rubber ring is inside the

connecting nut.

To release, turn off the water faucet and press the release

button to release the pressure of water then press down

the plate.

Make sure you leave the hot water lid attached. Do not

unscrew the lid of the hot water connector on the water

mixing valve and then connect the other end of the water

inlet hoses to the cold connector in water mixing valve by

turning the connecting nut.

If you have both cold and hot water supplied, connect the inlet hoses cold to cold and hot to hot.

Connect the water inlet hose to the tap connector by

turning the connecting nut.

To release, turn off the water faucet and turn on the

washer to run about 5 minutes and then disconnect the

inlet hoses.

Unscrew both lids on the water mixing valve, and then con-

nect the other end of water inlet hoses to the connectors in

water mixing valve by turning the connecting nut.

Note:

1. Do not over tighten or cross thread the nut in order to prevent the elbow of the water inlet from breaking.

2. If water seeps, you should check the nut for damage and make sure there is a rubber sealed ring.

Release

button

Connect-

ing nut

Water in-

let hose

Rubber

ring

Plate

Hot water

connector

Lid of hot wa-

ter connector

Water in-

let hose

Connect-

ing nut

Cold water

connector

Rubber

ring

Water in-

let hose

Water

faucet

Connect-

ing nut

Rubber

ring

Connect-

ing nut

Water in-

let hose

Hot water

connector

Rubber

ring

Cold water

connector

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Danby DWM045WDB User Manual Page 9

Comments to this Manuals

Related products and manuals for Washing machines Danby DWM045WDB