Danby DWM99W User Manual download pdf (Page 9)

• Connect fill hose (with 90

elbow) to either the

HOT/COLD water inlet valve located at the back

of the washing machine, tighten moderately.

(remember to install the “cap/plug” on the inlet

valve not being used)

• Connect the opposite end of the hose directly to

the body of the quick connect. Fig. F

• Attach the quick connect directly to the faucet

adapter, by pulling the outer collar (ring)

downward while pushing the quick connect

upward onto the faucet. Release the outer collar

(ring) and the quick connect will lock into place.

Fig. H

• Slowly open the water supply line and check for

any sign of leaks at all water connection points.

• If leaks occur, immediately close the water supply

and effect the necessary repairs and/or replace

ment of any/all defective connections. If you are

unable to effect suitable repairs yourself, call our

toll free CUSTOMER HELP LINE at

"1 800 26 DANBY and ask for assistance.

NOTE: Once the water supply line to the machine

is open, the inlet hose is pressurized. (even when

the water supply is closed immediately thereafter)

NOTE: Failure to relieve (release) hose pressure

before attempting to disconnect the hose from the

faucet can result in back pressure over-spray.

WARNING: Incoming water temperature can be

very hot and back pressure over-spray can cause

severe burns and/or scalding.

NOTE: To relieve (release) hose pressure, close

the water faucet. Press and "Hold" the "red"

(pressure relief) button located on the front (body)

of the quick connect until the flow of water stops.

Fig. F

When the flow of water has stopped, the hose

pressure is released and it is now safe to

disconnect the hose from the faucet adapter.

Permanent Hose Installation

(dual hose)

If your washing machine is to be permanently

installed both fill hoses are required. The following

accessories are not required for permanent

installation applications;

•Water Inlet Hose Quick Connect.

• Faucet Adapter.

• Water Inlet Valve Cap/Plug.

We recommend that you store these items in a safe

place for future use, in the event there is ever a

need to change your installation method.

Connecting the Water Inlet Hoses:

• Install a rubber washer into each end of both fill

hoses.

• Connect the both fill hoses (with the 90º elbow)

respectively to both the HOT & COLD water

valves located at the back of the washing machine

and tighten moderately. Fig. G

Rubber Ring

Connecting

Nut

Water

Inlet Hose

Outer

Collar

Pressure

Relief Button

Cold Water

Connection

Hot Water

Connection

Water Mixing

Valve

Water Inlet

Hoses

Water Supply

Faucets

Outer

Collar

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comments to this Manuals

No comments

Danby DWM99W User Manual Page 9

Comments to this Manuals