Danby DWM99W User Manual download pdf (Page 6)

WATER SUPPLY REQUIREMENTS

ARNING

Under certain conditions, hydrogen gas may be pro-

duced in a hot water system that has not been used

for two weeks or more. HYDROGEN GAS IS

EXPLOSIVE. If the hot water system has not been

used for such a period and before using the washer,

turn on all hot water faucets and let the water flow

from each for several minutes. This will release any

accumulated hydrogen gas.

THIS GAS IS FLAMMABLE, DO NOT SMOKE OR

USE AN OPEN FLAME DURING THIS TIME.

Water supply faucets must fit standard 3/4 inch

(19.05mm) female garden hose couplings.

DO NOT USE SLIP-ON OR CLAMP-ON CONNEC-

TIONS.

NOTE:

Water supply faucets should be readily accessible

to permit turning them off when the washer is not

being used.

ATER TEMPERATURE

Cold

Recommended cold water temperature is 50 ~ 75

10 ~ 23.8

Hot

Recommended hot water temperature is 135 ~

145

F, 57 ~ 62.7

Warm

Mixture of hot and cold water. (Warm water temper-

ature is dependent upon the water temperature and

the pressure of both the hot and cold water supply

lines.)

IMPORTANT: Owner should turn off water supply

whenever there will be an extended period of non-

use.

Water pressure

Do not operate the washer when the water pressure

is lower than 0.02 MPa or higher than .8 MPa. to

avoid damage of the inlet system.

Risers

Risers (or air cushions) may have to be installed if

the pipes knock or pound when flow of water stops.

The risers are more efficient when installed as close

as possible to the water supply faucets, see illustra-

tion below.

Cold Water

Connection

Hot Water

Connection

Water Mixing

Valve

Water Inlet

Hoses

Water Supply

Faucets

Water Supply

Faucets

Risers

(air cushions)

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Comments to this Manuals

No comments

Danby DWM99W User Manual Page 6

Comments to this Manuals