Danby DWM5500W User Manual download pdf (Page 9)

INSTALLATION INSTRUCTIONS

Instructions for Use

8

Placing and Installation

If the floor is uneven, use the adjustable feet to

level the machine.

• Undo the nuts. Rotate the feet to level the

machine (fig. 5).

• Fix the nuts (fig. 5.1).

Maximum height of the washing machine is

33.5 in.

IMPORTANT

The floor on which the machine stands should be

dry, otherwise the machine may slide during the

spinning cycle.

Connection to the Water Supply

The hose connections inclusive of the 90º elbow

and coupling must be connected to the water

inlet valves located on the rear wall of the

appliance. The hose connections inclusive of the

straight line coupling must be connected to the

water (faucet) supply (See Fig. 6)

. To ensure efficient operation, the water

pressure of the water supply should be between

7 and 116 psi.

If the pressure exceeds the maximum allowed

limit, fit a pressure regulator. (Open the tap fully -

in 15 seconds, 0.8 gal. of water should pour out;

and this is the minimum pressure of the water

supply).

Connection to hot/cold water

Washing machines designed for connections to

hot/cold water are equipped with two inlet hoses.

Each hose is identified with a “red” or “blue”

stripe running the entire length of the hose.

Red Stripe = Hot Water Hose Connection

Blue Stripe = Cold Water Hose Connection.

Insert rubber washer with screen (filter) inside

(straight line) coupling and connect to the

faucet/tap. (Fig. 6) Insert regular rubber washer

inside (90º) coupling and connect to water inlet

valve.

IMPORTANT

The highest allowed temperature of hot water is

140°F.

Water Outlet

Hook the outlet hose securely over the edge of

the washbasin or bath tub. The outlet hose can

also be connected directly to the plumbing outlet,

the diameter of which should be not less than 1.6

in. (fig. 7).

Wall siphon drain must be correctly fitted in such

manner to enable cleaning.

If water is drained through a washbasin, always

check it is drained quickly enough, otherwise an

overflow may occur or the machine may pump

the water back. Pull a string through the hole on

the plastic elbow, and secure the outlet hose to

prevent it from falling off (fig. 8).

The end of the outlet hose should be raised from

the floor by not more than 40 in. and not less

than 24 in. If the hose is positioned higher than

recommended, the machine will not pump out the

water.

Connection to Power Supply

Connect the appliance to the power supply using

the power cord. The electrical outlet should be

equipped with a properly grounded contact

(safety socket).

Rated voltage, frequency and other data are

listed on the rating plate of the machine.

Your washing machine should be grounded

and connected to the power supply according

to local electricity board regulations and

standards.

Connect to individual branch circuit.

WARNING!

If the supply cord is damaged, it must be

replaced by the manufacturer or his service

agent or a qualified person in order to avoid

hazard.

• The appliance must be installed so that power

cord plug is within reach of the appliance.

DO NOT USE AN EXTENSION CORD

7

8

5.1

5

6

cold hot

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comments to this Manuals

No comments