Danby DVAC12038EE Operations Instructions download pdf (Page 5)

Your unit is designed to evaporate condensation

under normal conditions. However, under

extreme humidity conditions, excess condensation

may cause basepan to overflow to the outside.

The Unit should be installed where condensation

run-off cannot drip on pedestrians or neighboring

properties.

Please refer to the Installation Manual for

detailed instructions on installing your

vertical Air Conditionner.

Select the Best Location

A. This room air conditioner is designed to fit easily

into a single or double hung window. However,

since window designs vary, it may be necessary

to make some modifications for safe, proper

installation.

B. Make sure window and frame are structurally

sound and free from dry and rotted wood.

C. For maximum efficiency, install the air conditioner

on a side of a house or building which favors

more shade than sunlight. If the unit is in direct

sunlight, it is advisable to provide an awning over

the unit.

D. Provide sufficient clearance around the cabinet to

allow for ample air circulation through the unit.

See Fig. 2. The rear of the unit should be

outdoors and not in a garage nor inside a

building. Keep unit as far away as possible from

a room should be prevented from blocking the air

flow.

E. Be certain the proper electrical outlet is within

reach of the installation. Use only a single

outlet circuit rated at 15 amps. All wiring should

be in accordance with local and national

electrical codes.

F. DO NOT USE "REGULAR" EXTENSION CORDS

WITH THIS UNIT. If it is necessary to use an

extension cord to connect your air conditioner,

use an approved "air conditioner" extension cord

only. (available at most local hardware stores)

G. DO NOT install unit where leakage of combustible

gas is suspected. Your air conditioner may fail to

operate in air containing oils (including machine

oils), sulfide gas, near hot springs, etc...

CAUTION

Because the compressor is located towards the

rear of the unit, this side will be heavier and more

awkward to manipulate. Therefore, it is

recommended to have someone assist you

during the installation of this unit.

Selecting the Best Location

Side

obstruction

Ground

Fence,

wall, or

other

obstacle.

Awning

Min.

Fig. 2

DVAC8036 FINAL OM-.qxp 2006.02.23 17:08 Page 10

Energy-Saving Tips

Your Vertical Room Air Conditioner is designed

to be highly efficient in energy savings.

Follow these recommendations for greater efficiency.

1. Select thermostat setting that suits your

comfort needs and leave thermostat at that

chosen setting.

2. The filter is very efficient in removing airborne

particles. Keep air filter clean. Normally, filter

should be cleaned every 2 weeks. More

frequent cleaning may be necessary depending

on indoor air quality.

3. Use drapes, curtains, or shades to keep

direct sunlight from heating room, but DO NOT

obstruct the air conditioner. Allow air to circulate

around the unit without obstruction.

4. Start your air conditioner before outdoor air

becomes hot and uncomfortable. This avoids an

initial period of discomfort while unit is cooling

off the room.

5. When outdoor temperatures are cool enough,

use HIGH or LOW FAN only. This circulates

indoor air, providing some cooling comfort, and

utilizes less electricity than when operating on a

cooling setting.

obstacles/obstructions and at least 30"(762mm) above

the floor or ground. Curtains and other objects within

20"(508mm)

12" (304mm) Min.

Min.

20"(508mm)

30"(762mm)

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Danby DVAC12038EE Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DVAC12038EE