Danby DKC146SLDB Operations Instructions download pdf (Page 8)

Installation Instructions

ELECTRICAL

CONNECTION (cont)

This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical

outlet with three-prong ground receptacle. The cord should be secured

behind the Beer Dispenser and not left exposed or dangling to prevent

accidental injury.

Never unplug the Beer Dispenser by pulling the power cord. Always grip

the plug firmly and pull straight out from the receptacle.

CO2 GAS CAN BE DANGEROUS

CO2 cylinders contain high-pressure compressed gas which can

be hazardous if not handled properly. Make sure you READ and

UNDERSTAND the following procedures for CO2 cylinders

BEFORE INSTALLATION.

WARNING

1. ALWAYS connect the CO2 cylinder to a regulator. Failure to do so

could result in explosion with possible injury when the cylinder valve is

opened.

2. NEVER connect the CO2 cylinder directly to the product container.

3. ALWAYS follow correct procedures when cylinders are changed.

4. ALWAYS secure the cylinder in an upright position.

5. NEVER drop or throw a CO2 cylinder.

6. ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in

a cool place (preferably 70°F). Securely fasten with a chain in an

upright position when storing.

7. ALWAYS ventilate and leave the area immediately if CO2 leakage has

occurred.

8. ALWAYS check the D.O.T. test date on the cylinder neck before

installation. If over five (5) years, do not use, return cylinder to gas

supplier.

9. NEVER connect a product container unless there are two (2) safety’s in

the pressure system:

a. One at or on the CO2 regulator

b. One at or on the product coupler or in the pressure gas line.

Beer Keg Installation Instructions

CO2 TANK

RED PRESSURE HOSE

KEG

AMERICAN

SANKEY TAP

CLEAR HOSE

WITH WING NUT

TOWER

FAUCET ASSEMB

SINGLE GAUGE

PRESSURE

REGULATOR

TOWER

Keg Installation Sketch

• Install the four castors with lock provided into the unit’s bottom (four

screw holes pre-supplied) The two metal gaskets are used for the front

two Castors. Figure (1) before installation. Figure (II) is the final version.

METAL

WASHERS

Figure 1 Figure 2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 44 45

Comments to this Manuals

No comments

Danby DKC146SLDB Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DKC146SLDB