Danby DKC644BLS Owner's Manual download pdf (Page 10)

1. Un-instafl Work top: Using a Phillips Screwdriver, remove the

three screws located at the rear (back) side of the Work top.

See Fig's. 1 & 2 Lift the Work top from the rear, titling towards

the front of the cabinet.

Pleasenote: Do not attempt to completely seperate the work

top from the cabinet, as this can lead to damage or

disconnection of the control wiring.

2. Installation of Top Raih Attach the chrome rails to the

worktop using six self-tapping screws (included) from the

under side of the Work top through the pre-drilled holes.

(attach the front ends of the rail first)

Fig. 1

3. Reqnstall Work top: Install the front of the Work top onto

the cabinet, then lower the rear side of the Work top over the

backside of the cabinet. Secure using the same screws

removed earlier.

4. Installation of CO 2 Cylinder Support: install the cylinder

support onto the four studs located on the exterior back

wall of the cabinet. (no tools required) Align the holes in

the cylinder support with the studs and push down firmly.

See Fig. 3

Fig. 2

5. Installation of CO 2 Cylinder: install your " fully charged"

CO 2 cylinder into the support stand.

IMPORTANT NOTICE: ALWAYS EXERCISE EXTREME

CAUTION WHEN HANDLING PRESSURIZED C0 2

CYLINDERS.

6. Installation of C0 2 Regulator: Attach the CO 2 Regulator to

the C0 2 cylinder by screwing the regulator nut onto cylinder

valve and tighten (snug) using an adjustable wrench.

See Fig. 4

Fig. 3

Fig. 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Danby DKC644BLS Owner's Manual Page 10