Danby ADR70B1C User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
There are two ways to remove collected water.
A. Use the bucket
When the unit is off and the bucket is full, the unit will beep 8 times, the
Bucket Full indicator light will À ash, and the digital display shows P2.
When the unit is on and the bucket is full, the compressor turns off and
the fan turns off after drying the water off the condenser for 30 seconds.
The unit will then beep 8 times and the Bucket Full indicator light will
À ash, and the digital display shows P2.
To empty the full bucket, slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull it straight out so water does not
spill. Do not put the tank on the À oor because the bottom of the bucket
is uneven. Otherwise the bucket will fall and cause the water to spill.
Discard the water and return the bucket to the unit. The bucket must
be in place and properly positioned for the dehumidi¿ er to operate. The
machine will re-start when the bucket is restored in its correct position.
NOTE:
When you remove the bucket, do not touch any parts inside of the unit.
Doing so may damage the product. Be sure to push the bucket gently
all the way into the unit. Banging the bucket against anything or failing
to push it in securely may cause the unit not to operate. When you
remove the bucket, if there is some water inside the unit you must dry it.
A1. Pull the bucket out a little
A2. Hold both sides of the bucket with
even strength, and pull it out from the
unit. Pour the water out.
B. Continuous draining
Water can be automatically emptied into a À oor drain by attaching the
unit to a ID 5/16” water hose with a ID:M=1 female threaded
end (not included). Install the drain hose onto the adaptor A (see B1).
The adaptor is found in the accessory bag located in the bucket.
Remove the plastic cover from the back drain outlet of the unit and set it
aside. Remove the bucket, then insert the drain hose through the drain
outlet of the unit and securely press it into the connector on the front of
the unit. (See B2.)
Tighten the adaptor A and the unit by using two screws (found in the
accessory bag located in the bucket upon purchase). Install the female
threaded end of the water hose into the adaptor A. (See B4), then lead
the water hose to the À oor drain or a suitable drainage facility. Make
sure the hose is secure so there are no leaks. Direct the hose toward
the drain, making sure that there are no kinks that will stop the water
from À owing. Place the end of the hose into the drain and make sure
the end of the hose is level or declining to let the water À ow smoothly.
Place the bucket back in the unit and make sure that it is located
correctly. Select the desired humidity setting and fan speed on the unit
for continuous draining to start.
B1.
B2.
B3.
B4.
Accessories (for continuous drain):
OPERATION INSTRUCTIONS
REMOVING COLLECTED
WATER
Drain hose
Adaptor A
Plastic cover
Drain hose
subassembly
Connector
Drain hose
Water hose
Female thread
end
Drain hose (1 pc) Adaptor A (1 pc) Screw (2 pc)
9
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments