Danby DPAC 5009 Operations Instructions download pdf (Page 8)

TIMER SETTING CONTROL

Press the Timer button on the remote control to set the timer. The ON or OFF logos (depending

on timer modes “A” or “B” below) will appear in the display panel, and the clock symbol will

flash for approx. 10 seconds; the display panel will show a time of 8 hrs. While the clock

symbol is flashing, press the and buttons on the remote control to select the time (in

hours between 00 and 24) for either of the timer modes “A” or “B” (see below). The time

selected will be shown on the display panel and after approximately 10 seconds, the clock

symbol will remain illuminated together with either the ON or OFF logo.

Timer Mode A) Auto Turn Off:

With the machine on and running, set the timer to select the number of hours you would like

the unit to run until it automatically shuts off. The set time will be shown in the display together

with the clock symbol and the OFF logo.

Tiimer Mode B) Auto Turn On:

Switch the machine on using the ON / OFF button (either on the machine itself or on the

remote control) so that the machine is running and the desired mode is selected. Press the

ON/OFF button again to put the machine into stand-by mode. Set the timer to select the

number of hours until it is required for the machine to start up automatically. The set time will

be shwon in the display together with the clock symbol and the ON logo.

TIMER CANCEL CONTROL

If the time has been set as in either “A” or “B” above and it is then decided that the timer is not

required, pressing the CANCEL button will turn the timer off.

Auto mode

Cooling mode

Dehumidify mode

Fan only mode

High fan speed

Med. fan speed

Low fan speed

Display set temperature

Display timer setting of auto switch on/off

OPERATION (cont’d)

FEATURES OF THE

LCD DISPLAY (cont’d)

LCD DISPLAY

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Danby DPAC 5009 Operations Instructions Page 8