Danby DPAC 5009 Operations Instructions Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
6
POWER CONTROL
The power control turns the unit on and off.
MODE CONTROL
The mode control has 4 settings:
• Cool • Dehumidifiy • Fan • Auto
The settings are adjustabed by the Mode Control button.
COOLING MODE
During the cooling mode, the air is cooled and hot air is exhausted
outside through the exhaust tube. Adjust fan speed and temperature to
suit your desired comfort level.
Note: The air exchange hoses must vent outside the room when using
Cool mode.
DEHUMIDIFY MODE
Air is dehumidified as it passes through the air conditioner, without
being in full cooling mode. If room temperatures is higher than 25°C
(77°F), fan speed can be adjusted; otherwise fan speed is fixed to
“low”.
FAN MODE
Air is circulated throughout the room with no cooling.
Note: Unit does not need to be vented in Fan mode.
AUTO MODE
In auto mode the unit will switch mode and fan speed automatically based on the ambient
temperature.
On/Off
Switch
LCD
Display
FAN SPEED CONTROL
The fan speed control has 4 settings: Auto (Cooling
only), High, Medium, and Low.
TEMP. SET CONTROLS
The temperature can be set by means of the
and buttons on the remote control. The
temperature can be set between 16°C (61°F ) and
32°C (89°F). Pressing the and buttons will
cause the set temperature to remain in the display
panel for approximately 5 seconds. The display will
then revert back to showing the current room
temperature.
Note: It is only possible to set the temperature when in COOLING MODE. The temperature
can not be set when in AUTO, DEHUMIDIFYING or FAN mode.
FAHRENHEIT / CELSIUS SELECTOR
Pressing this button will switch the display between degrees Celsius and degrees Fahrenheit
Note: Initial setting is °C
OPERATION
REMOTE
CONTROL
FEATURES OF THE
LCD DISPLAY
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments