Danby DPAC 5009 Operations Instructions download pdf (Page 12)

CAUTION: Before cleaning or servicing this unit, disconnect from any electrical supply outlets.

1) DO NOT use gasoline, benzene, thinner, or any other chemicals to clean this unit, as these

substances may cause damage to the finish and deformation of plastic parts.

2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this

will cause deterioration of electrical components and wiring insulation.

3) Unplug the unit.

4) Clean the unit by wiping off any dirt/dust with a soft damp cloth or vacuum cleaner, then wipe dry

with a dry soft cloth.

CAUTION: Always store the unit in vertical position. DO NOT put heavy objects on top of the unit.

If the air filter becomes clogged with dust/dirt, air flow is

restricted, which reduces cooling efficiency. The air filter

should be cleaned every two (2) weeks. More frequent

cleaning may be necessary depending on indoor air quality.

NOTE: The air filter is located at the upper rear side of the

unit.

1) To remove the air filter: Pull the air filter cover upward in

the direction of the arrow (Fig.4) and remove the air filter.

2) Dust/dirt clogged in the filter can be removed by vacuum

cleaning the soiled areas.

3) The filter can also be washed in lukewarm, soapy water

while rubbing it lightly with a brush. A mild detergent

(diswashing liquid) is recommended.

4) Rinse the filter well using clean water. Allow time to dry

before reinstalling into the unit.

5) Replace the air filter and cover.

6) Replacement air filter information is available by

contacting the Customer Service Department at:

1-800-26-

1-800-263-2629

CAUTION: Never operate this unit without the air filter in place, as

this may result in damage to the unit.

Fig. 4

CARE AND MAINTENANCE

CLEANING

THE UNIT

CLEANING THE

AIR FILTER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Danby DPAC 5009 Operations Instructions Page 12